11. Connect the two optical fi ber cables to the op-
tical module on the SDP-16 board.
m
. Clean the connectors before connecting the
optical fi ber cables. (Refer to Section 2-8.)
. Check cable numbers when connecting
optical fi ber cables, and insert the cable
connector as far as it will go.
12 Extend the optical fi ber cables between parts
and through the notch of the SDP-16 shield
plate as shown in the fi gure, and clamp the
cables with the harness clamp.
13. Extend the two optical fi ber cables and the
harness (2P) as shown in the fi gure and clamp
them with the harness clamps.
n
Extend the harness (2P) between the CN-
2672GA board and the rear panel as shown in
the fi gure.
14. Attach the fi ber cable cover and the cover
(SDP-16) with four screws. (Refer to step 2.)
15. Install the rear panel assembly (HKCU-
HB10). (Refer to Section 1-3-1.)
3-4 (E)
SDP-16 shield plate
SDP-16 shield plate
SDP-16 board
SDP-16 board
Harness clamp
Harness clamp
Harness (2P)
Harness (2P)
CN-2672GA board
CN-2672GA board
Rear panel
Rear panel
Notch
Notch
Harness clamp
Harness clamp
Optical fiber cables
Optical fiber cables
1
1
Optical module
Optical module
Optical fiber cables
Optical fiber cables
2
2
HKCU-HB10