Installation; Overview Of Installation - Sony HKCU-HB10 Maintenance Manual

1-1. Overview of Installation

Components
This unit consists of the following components.
HKCU-HB10
. Rear panel assembly
(Optical multi cable assembly, CN-2672GA board,
SDP-16 board)
. Harness (REMOTE)
. SDP-16 heat sink
. Heat transfer sheet
. Conductive cushion
. Labels
HKCU-HB15
. Rear panel assembly
(Optical multi cable assembly, SDP-16 board)
. Heatsink
. Heat transfer sheet
. Conductive cushion
. Labels
HKCU2005
. DRX-8 board
. HIF-57 board
. Indication label (DRX-B)
Applicable model
HKCU-HB10
HDCU1000
. 14001 and Higher (HDCU1000: UC)
. 41001 and Higher (HDCU1000: CE)
. 50001 and Higher (HDCU1000: E3)
. 60001 and Higher (HDCU1000: E2)
n
This procedure is not available for the following serial
numbers.
. 10001 to 13999 (HDCU1000: UC)
. 40001 to 40999 (HDCU1000: CE)
HKCU-HB10
Section 1

Installation

n
Uninstallable serial numbers
. 10001 to 13999 (UC)
. 400001 to 409999 (CE)
Installable serial numbers
. 14001 and Higher (UC)
. 410001 and Higher (CE)
HKCU-HB15
HDCU1500
HKCU2005
. HDCU1000 (HKCU-HB10)
. 14001 and Higher (HDCU1000: UC)
. 410001 and Higher (HDCU1000: CE)
. HDCU1500 (HKCU-HB15)
m
. This unit can be installed only to HDCU1000 with
HKCU-HB10 installed or HDCU1500 with HKCU-
HB15 installed.
. When the camera format is set to 1080/59.94P or
1080/50P with the DRX-5 board (excluding the DRX-5A
board) mounted in slot 2, even if switch S410 (HD-SD
delay mode) on the AT-167 board is set to 0-DLY, this
setting is treated as FRAME-DLY.
The down-converted SD output is delayed by one frame.
2
SDI OUT
SDI
1
2
3
4
1-1 (E)