Actions To Be Taken After Installing This Kit - Sony HKCU-HB10 Maintenance Manual

1-4. Actions to be taken after installing this kit

Perform the following after this kit is installed.
. Upgrade the software version.
n
For more information, contact your local Sony Sales Offi ce/Service Center.
. After the software is upgraded, change the TRANSMIT setting from HD-SDI to AUTO on the C07
<PROMPT/TRUNK> page of the CCU CONFIGURATION menu. (Refer to Section 4-4.)
. Upgrade the PLDs on the following boards. (Refer to Section 2-5.)
. AT-167 board
. AVP-6/6A board
. DRX-5/5A board
. DTX-5 board
. Change the transmission format and the format setting for each output pin according to the output signal
confi guration required by the customer.
HKCU-HB10
1-21 (E)