Sony HKCU-HB10 Maintenance Manual page 22

8. Connect the SDP-16 board of HKCU-HB15
to the MB-1072/1072G board.
9. Connect the harness that was disconnected in
step 6 to the connector CN104 on the SDP-16
board.
10. Connect the power cable of the optical multi
cable assembly to the power supply unit.
11. Install the rear panel with eight screws.
m
. When installing the rear panel, tighten the
four screws fi rst in the order shown in the
fi gure.
. Install the rear panel so that the optical fi ber
cables are not stressed.
12. Attach all the blank panels with four screws.
m
. When the option board is mounted in slot 2
or a subsequent slot, remove the option
board and reinstall it to its original slot.
. After all option boards and blank panels
have been installed, secure them with
screws.
. Be sure to install blank panels to open slots.
1-16 (E)
MB-1072/1072G board MB-1072/1072G board Connector of power unit Connector of power unit
2 2
3 3
SDP-16 board SDP-16 board
Rear panel assembly Rear panel assembly
1 1
2 2
Power cable Power cable
Harness (ETHER) Harness (ETHER)
CN104 CN104
Blank panels Blank panels
B3 x 5 B3 x 5
B3 x 5 B3 x 5
4 4
3 3
HKCU-HB10