Sony HKCU-HB10 Maintenance Manual page 56

4. Open the harness clamp on the SDP-16 board
and disconnect the two optical fi ber cables
from the optical module.
m
. If optical fi ber cable is bent or pulled
strongly, it may be disconnected (especially
at the connector-cable connecting point).
Handle optical fi ber cables carefully.
. Do not touch the tip of the optical fi ber
cable. This may result in deterioration of
signals.
5. Remove the two UL tapes and disconnect the
harness (2P) of the optical multi cable assem-
bly from the connector CN103 on the SDP-16
board.
6. Remove the four screws and remove the
optical multi cable assembly and the washer.
7. Remove the four screws to detach the fi ber
CN holder from the optical multi cable as-
sembly.
3-2 (E)
CN103 CN103
Harness (2P) Harness (2P)
UL tapes UL tapes
Washer Washer
PS3 x 8 PS3 x 8
Optical multi cable assembly Optical multi cable assembly
Fiber CN holder Fiber CN holder
Optical fiber cables Optical fiber cables
Harness clamp Harness clamp
Optical module Optical module
SDP-16 board SDP-16 board
PS3 x 8 PS3 x 8
PS3 x 8 PS3 x 8
1 1
2 2
HKCU-HB10