Omron SYSMAC C200H Installation Manual page 64

Mounting Requirements
DIN Track Mounting Bracket
Procedure
1, 2, 3...
DIN Track
Mounting
Bracket
This claw fits into the DIN track
Backplane
56
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The DIN Track Mounting Bracket shown below is necessary for mounting the PC
to the DIN Track.
DIN Track Mounting Bracket
DIN
1. The following diagram is a view of the back of the Backplane. Attach one
Mounting Bracket to the left and right sides of the Backplane as shown be-
low.
Backplane
2. Mount the Backplane to the DIN Track so that the claws on the Mounting
Brackets fit into the upper portion of the DIN Track as shown below.
Specification
One set (two brackets)
50 cm long, 7.3 mm high
1 m long, 7.3 mm high
1 m long, 16 mm high
There are two
Backplane mounting
screws each on the
left and right sides of
the Backplane. Use
these screws to
attach the DIN Track
Mounting Brackets to
the Backplane.
DIN track
DIN Track Mounting Bracket
Section 5-2
Model
C200H-DIN01
PFP-50N
PFP-100N
PFP-100N2