Safety During Operation; Safety During Maintenance; 1.13.1 Disconnecting And Securing The Geared Drill; 1.13.2 Using Lifting Equipment - Optimum OPTIdrill B 50GSM Operating Manual

1.12

Safety during operation

We specially point out the specific dangers when working with and on the geared drill.
WARNING!
Before switching on the geared drill make sure that there are no
no dangers generated for persons,

not cause damage to equipment.

Avoid any risky working practices:
Make sure that nobody is endangered by your work.

The instructions mentioned in these operating instructions have to be strictly observed dur-

ing assembly, operation, maintenance and repair.
Do not work on the geared drill, if your concentration is reduced, for example, because you

are taking medication.
Observe the accident prevention regulations issued by your Employers Liability Insurance

Association or other competent supervisory authority, responsible for your company.
Inform the supervisor about all endangerments or errors.

Stay at the geared drill until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work

suit and, if necessary, a hairnet.
Do not use protective gloves when drilling or milling.

1.13

Safety during maintenance

Inform the operators in good time about any maintenance and repair works.
Report all safety relevant changes and performance details of the geared drill. Document all
changes, have the operating instructions updated accordingly and train machine operators.

1.13.1 Disconnecting and securing the geared drill.

Turn off the main switch of the geared drill before starting any maintenance or repair work.
Use a padlock to prevent the switch from being turned on without authorization and keep the
key in a safe place.
All machine parts as well as any dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
Attach a warning sign on the machine.

1.13.2 Using lifting equipment

WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death.
Check that the lifting and load suspension gear
they have sufficient load carrying

and that it is in perfect condition.

Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other competent supervisory authority, responsible for your
company.
Fasten the loads properly. Never walk under suspended loads!

1.13.3 Mechanical maintenance work

Remove or install protection safety devices before starting any maintenance work and re-install
them once the work has been completed.This includes:
Safety
Version 1.1.5 - 2022-06-22 Translation of original instruction
B50 GSM EN
15