Safety During Operation; Safety During Maintenance; Disconnecting And Securing The Drilling Machine; Mechanical Maintenance Work - Optimum OPTIdrill DH 24BV Operating Manual

Personal protective equipment for special works
Protect your face and your eyes: Wear a safety helmet with facial protection when performing
works where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
1.15

Safety during operation

We specifically point out the dangers when describing the work with and on the drilling
machine.
WARNING!
Before switching on the drilling machine make sure that there are
no dangers generated for persons,

no objects are damaged.

Avoid any unsafe work methods:
Make sure that nobody is endangered by your work.

The instructions mentioned in these operating instructions have to be strictly observed dur-

ing assembly, operation, maintenance and repair.
Do not work on the drilling machine, if your concentration is reduced, for example, because

you are taking medication.
Observe the accident prevention regulations issued by your Employers Liability Insurance

Association or other supervisory authorities responsible for your company.
Inform the supervisor about all hazards or faults.

Stay on the drilling machine until the machine completely stopped moving.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work

suit and, if necessary, a hairnet.
Do not use protective gloves when drilling.

1.16

Safety during maintenance

Inform the operators in good time of any maintenance and repair works.
Report all safety relevant changes and performance details of the drilling machine or their oper-
ational behaviour. Any changes must be documented, the operating instructions updated and
machine operators instructed accordingly.
1.17

Disconnecting and securing the drilling machine

Switch off the drilling machine with the main switch and secure the main switch with a padlock-
against unauthorised switching-on or switching-on by accident.
All machine parts as well as any dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
1.18

Mechanical maintenance work

Reinstall all protection and safety devices after any maintenance work once the work has been
completed.This includes:
covers,

safety instructions and warning signs,

grounding cables.

Check if they are working properly!
EN
DH24BV | DH28BV | DH34BV | DH40BV
16 Translation of original instruction
Safety
Version 1.1.3 - 2020-07-23