Possible Error Messages - Hart® Devices From Sw-Rev. 3.00 - ABB TTH300 Operating Instruction

70 TTH300 HEAD-MOUNT TEMPERATURE TRANSMITTER | OI/TTH300-EN REV. G
... 11 Diagnosis / error messages
Possible error messages – HART® devices from SW-Rev. 3.00
Note
The listed causes for a device status message correspond to the delivery status. They can be configured freely in the tools in the
menu "Diagnosis/NAMUR configuration", see interface description COM/TTX300/HART.
Range Device status message
(on the display)
Sensor Line resistance S1 too high
Sensor S1 short-circuit
Sensor S1 Wire break / sensor break
Sensor S1 Single-point trim is active
Sensor S1 Two-point trim is active
Sensor Line resistance S2 too high
Sensor S2 short-circuit
Sensor S2 Wire break / sensor break
Sensor S2 Single-point trim active
Sensor S2 Two-point trim active
Sensor Redundancy: S1 not available
Sensor Redundancy: S2 not available
Sensor Sensor drift detected
Sensor Application failure
Operation Diagnostics is simulated
Operation Analog output fixed / simulated
Operation Application warning
Electronics Electronics temp. measurement failure
Electronics Electronics temp. out of spec.
Electronics Non-volatile data defect
Electronics Non-vol. Memory Write cycles exceeded
Electronics Device not calibrated
Electronics Electronics failure
Process S1 over sensor range
Process S1 under sensor range
Process S2 over sensor range
Process S2 under sensor range
Process High limit: Alarm
Process Low limit: Alarm
Process High limit: Warning
Process Low limit: Warning
Configuration Parameterization / config. failure
Note
If the remedial measures listed for the error message do not improve the status of the device, please consult ABB Service.
Cause Remedy
Maintenance required Check sensor or replace / repair sensor
Maintenance required Check sensor or replace / repair sensor
Maintenance required Check sensor or replace / repair sensor
Check function
Check function
Maintenance required Check sensor or replace / repair sensor
Maintenance required Check sensor or replace / repair sensor
Maintenance required Check sensor or replace / repair sensor
Check function
Check function
Maintenance required Check sensor or replace / repair sensor S1
Maintenance required Check sensor or replace / repair sensor S2
Maintenance required Check Sensor/ connection / trim / drift parameter
Error Check sensor connection / check HART variable
mapping
Check function Terminate / come out of simulation
Check function Terminate / come out of simulation
Check function Load valid parameter restart (reset) check S1 / S2
Error Restart (RESET) or replace transmitter
Out of specification Observe spec. ambient temp. range
Error Restart (RESET) or replace transmitter
Maintenance required Restart (RESET) or replace transmitter
Error Restart (RESET) or replace transmitter
Error Restart (RESET) or replace transmitter
Maintenance required Check sensortype use diff. sensor if required
Maintenance required Check sensortype use diff. sensor if required
Maintenance required Check sensortype use diff. sensor if required
Maintenance required Check sensortype use diff. sensor if required
Out of specification Verify process or change limit value
Out of specification Verify process or change limit value
Out of specification Verify process or change limit value
Out of specification Verify process or change limit value
Error Load valid param restart (RESET), reset to factory