Possible Hart Error Messages - ABB TTF200 Operating Instruction

30 TTF200 FIELD-MOUNT TEMPERATURE TRANSMITTER | OI/TTF200-EN REV. A
9.1

Possible HART error messages

Range Displays
the
device
status
Electronics F
Electronics S
Electronics F
Electronics M
Electronics F
Electronics I
Installation / I
Configuration
Electronics I
Electronics F
Electronics F
Electronics F
Installation / C
Configuration
Sensor F
Sensor F
Sensor F
Sensor F
Sensor F
Installation / I
Configuration
Installation / I
Configuration
Installation / F
Configuration
Installation / C
Configuration
Operating conditions F
Installation / I
Configuration
Installation / C
Configuration
Operating conditions S
NOTICE
If the remedial measures listed for the error message do not improve the status of the device, please consult ABB Service.
Change from one to two columns
Displays Cause
the DIAG.
NO.
1 Device defective
2 Ambient temperature overshot /
undershot
3 EEPROM defective
4 Electronics overload
5 Memory error
7 LCD display connected
8 Device write-protected
9 EEPROM busy
12 Sensor input defective (communication)
13 Sensor input defective (error)
14 Sensor input defective (ADC error)
32 Diagnostics simulation mode
34 Measuring error, sensor
35 Short-circuit, sensor
36 Wire break, sensor
37 Range overshot, sensor
38 Range undershot, sensor
41 Single-point adjustment active, sensor
42 Two-point adjustment active, sensor
65 Configuration defective
71 Reconfiguration is running
72 Error in the application
74 Analog output adjustment active
75 Analog output in simulation
76 Values overshot
Remedy
Replace the device
Check environment; reposition measuring
point if required
Replace the device
Factory reset
Factory reset
Status info; not an error
Status info; not an error
Status info; not an error
Replace the device
Replace the device
Replace the device
Not an error, diagnostic info, measurement
OK
Check sensor connection
Check sensor connection
Check sensor connection
Check measuring limits
Check measuring limits
Status info; not an error
Status info; not an error
Check configuration:
A) Wrong device
B) Span is too small
C) Incorrect configuration data
Status info; not an error
Check configuration, connections; reset to
factory settings
Status info; not an error
Status info; not an error
Check parameters:
A) Sensor limits overshot
B) Span is too small