Parameter Overview Hart® (For Devices To Sw-Rev. 1.03) - ABB TTH300 Operating Instruction

40 TTH300 HEAD-MOUNT TEMPERATURE TRANSMITTER | OI/TTH300-EN REV. G
... 10 Operation
Parameter overview HART® (for devices to SW-Rev. 1.03)
Note
This overview of parameters shows all the menus and parameters available on the device. Depending on the version and
configuration of the device, not all of the menus and parameters may be visible in it.
Devices to SW-Rev. 1.03 and from SW-Rev. 3.00 have partly different menus and parameters. The options for process variable
representation are increased from SW-Rev. 3.00. Additional device and diagnostic information is provided. The setting and canceling
of write protection has changed.
In addition, for devices from SW-Rev. 3.00, additional information (event and configuration monitor, see interface description HART,
COM/TTX300/HART) and detailed diagnostics can be displayed and configured in tools / drivers such as FIM and DTM.
Device Setup 1
Device Info 2
Display 3
Process Alarm 4
Communication 5
Write protection
Input Sensor 1
Input Sensor 2
Input / output assignment
Measured range
Damping
Factory reset
Device Type
Serial Number
Software Version
Hardware Version
HART TAG
HART Descriptor
Operation Time
Display Value
Bargraph
Bargraph View
Language
Contrast
Fault signaling
HART TAG
Address (Multidrop)
HART Burstmode
HART Resp. Preambles
Sensor Type
R-Connection
2-wire Resistance
Thermocouple RJ
ext. Thermocouple RJ
Engeneering Unit
Measured Range Begin
Measured Range End