Definition Of Programmable Output 1-5; Defined Contents Of Programmable Output 1-5 - Smartgen APC715 User Manual

7.2 DEFINITION OF PROGRAMMABLE OUTPUT 1-5

7.2.1

DEFINED CONTENTS OF PROGRAMMABLE OUTPUT 1-5

Table 14 Defined Contents of Programmable Output 1-5
No.
0 Not Used
1 Custom Period 1
2 Custom Period 2
3 Custom Period 3
4 Custom Period 4
5 Custom Period 5
6 Custom Period 6
7 Custom Combined 1
8 Custom Combined 2
9 Custom Combined 3
10 Custom Combined 4
11 Custom Combined 5
12 Custom Combined 6
13 Reserved
14 Reserved
15 Reserved
16 Start Relay B
17 Air Flap
18 Audible Alarm
19 Louver Control
20 Fuel Pump Control
21 Heater Control
22 Cooler Control
23 Oil Pre-supply
24 Reserved
APC715 Pump Unit Controller User Manual
Type
Details of function description please see the
following.
If "Start Relay B" is configured, start relay and
start relay B will output
multi-startup process; can be used to control
double power supply ATS.
Action when over speed shutdown and
emergence stop. It can close the air inflow to
stop the engine as soon as possible.
Action when warning or shutdown occurs.
Can be connected annunciator externally.
When "alarm mute" input port is active, the
alarm will be prohibit.
Action in genset starting and disconnect
when genset stopped completely.
It is controlled by fuel pump of level sensor's
limited threshold.
It is controlled by heating of temperature
sensor's limited threshold.
It is controlled by cooler of temperature
sensor's limited threshold.
Actions in period of cranking to safety run.
Description
alternately in
Page 36 of 62