Proper Environment; Llumination - MICRO-EPSILON surfaceCONTROL 2500 Operating Instructions Manual

llumination

CAUTION
surfaceCONTROL 2500
1.6

Proper Environment

- Protection class : IP40 (only applies in the case of connected output connectors and/
1
or installed protective caps)
- Temperature Range operation:
ƒ +5 ... +40 °C (+41 ... +104 °F); for free air circulation
ƒ It is recommended to recalibrate the sensor in case of temperature fluctuations du-
ring operation of more than 5 K.
ƒ For temperature differences of more than 10 K (e.g. after transport to another loca-
tion), the sensor may only be put into operation after a period of approx. 1 h.
- Temperature range storage: -10 ... +50 °C (+14 ... +122 °F);
- Ambient pressure:
- Humidity
ƒ Operation:
ƒ Storage:
2. llumination
The surfaceCONTROL 2500 sensor has an LED lighting unit with a high-power LED of
wavelength 462 nm (blue), 528 nm (green) or 612 nm (red) depending on the model.
The LEDs belong to the risk group 2 according to EN 62471: 2010-06.
Do not look into the lens. Consciously close your eyes or immediately turn away if the
optical radiation enters the eye.
> Risk of damage to the eyes by optical radiation!
The following information label is attached to the front of the sensor housing:
Fig. 1 LED warning label
1) The protection class does not apply for the optical sections during operation as their
soiling / contamination results in adversely affecting or failure of the function.
at max. 90 % relative humidity
Atmospheric pressure
20 ... 80 % (non-condensing)
10 ... 90 % (non-condensing)
Page 7