Using The Configure Menu; Setting The Time And Date - Elitech NANODUCT 1030 User Manual

Section 2 : Initial System Setup
SETUP MENU
2019-03-24 12:04
Exit
Configure
Self Test
Demo Mode
CONFIGURE MENU
Exit
Set Clock
Set Options
Set Language
Set Clock
2019-03-24 12:07
Set Time
Set Date
Exit
Set 24 Hour Clock
12:07
SELECT To Adjust
ENTER To Set
Using the Configure Menu
Use the Configure Menu to set the clock, display language, for suppressing or
displaying test results, and forcing a Calibration Check when the instrument is
turned on.
1. Select "Configure" from the SETUP MENU and press ENTER.

Setting the Time and Date

Setting Time
1. To set or adjust the clock, from the CONFIGURE MENU select "Set Clock"
and press ENTER.
2. Select "Set Time" and press ENTER. The display shows the "Set 24 Hour
Clock" screen with the hour digits flashing. Pressing the SELECT key
increments the hours one hour at a time. Pressing and keeping the
SELECT key held down increments through the hours at a slightly faster
rate. After reaching 23, the hour returns to 00.
With the desired hour displayed, press ENTER to set the hours. The screen
then displays "Set Minutes" with the minutes digits flashing.
23