Section 2: Initial System Setup; Installing Or Replacing The Batteries - Elitech NANODUCT 1030 User Manual

Section 2: Initial System Setup

2.1 Installing or Replacing the Batteries

1. The battery compartment is on the back of the instrument. Turn the
instrument so that the back is facing up. Using a Phillips screwdriver,
remove the two screws that are holding the battery door in place. Remove
the battery door.
2. Insert four fresh alkaline AA batteries (ANSI/NEDA 15A, IEC LR6) making
sure that each battery is inserted with the correct orientation as shown.
There are markings within the battery holder that show proper orientation of
the batteries.
3. Reposition the battery door and insert the screws. Using a Phillips
screwdriver, tighten the two screws that hold the door in place.
4. Dispose of the spent batteries according to battery manufacturer's
instructions and local regulations.
NOTE: Batteries are installed in the instrument at the time of shipment. Unless
the Low Battery message displays, the batteries do not need to be replaced.
If you are not using the instrument for an extended period of time, remove the
batteries. Batteries can leak and damage terminals if left unused for extended
periods.
WARNING!
Do not install batteries backwards, charge, put in fire or mix with other
battery types. Batteries may explode or leak causing injury. Replace all
batteries at the same time.
21