Fixing The Field Controller To A Holder And Pole - Leica Viva TS16 User Manual

4.6
Components of the
GHT66 holder
Fixing the field
controller and GHT66
to a pole step-by-
step
44
2. Adjust the angle of TCPS29/30 until it is vertical.
3. Adjust the location of the adapter on the tripod leg so that there
are no metallic objects in the horizontal plane around the antenna.
☞
Metallic objects near the antenna disturb radio transmis-
sions.
4.
☞
To achieve the best performance from the TCPS29/30,
mount it in a vertical position on the tripod leg, approxim-
ately 30cm from the top.
008645_001
☞
If the adapter is no longer able to retain its angle position,
the adjustment bolt at the hinge can be tightened slightly.

Fixing the Field Controller to a Holder and Pole

The GHT66 holder consists of the following components:
a
b
c
008545_001
For an aluminium pole, fit the plastic sleeve to the pole clamp.
☞
1. Insert the pole into the clamp hole.
2. Attach the holder to the clamp using the clamp bolt.
3. Adjust the angle and the height of the holder on the pole to a com-
fortable position.
4. Tighten the clamp with the clamp bolt.
GHT63 clamp
d
a Plastic sleeve
e
b Pole clamp
c Clamp bolt
GHT66 holder
f
d Locking pin
g
e Top clip
h
f Mounting plate
i
g Bottom clip
h Tightening screw
i Mounting arm
Operation