Fixing The Field Controller To A Holder And Pole - Leica TS13 User Manual

4.3
Components of the
GHT66 holder
Fixing the field
controller and GHT66
to a pole step-by-
step
Operation

Fixing the Field Controller to a Holder and Pole

The GHT66 holder consists of the following components:
a
b
c
008545_001
☞
For an aluminium pole, fit the plastic sleeve to the pole clamp.
1. Insert the pole into the clamp hole.
2. Attach the holder to the clamp using the clamp bolt.
3. Adjust the angle and the height of the holder on the pole to a com-
fortable position.
4. Tighten the clamp with the clamp bolt.
5. Before placing the CS field controller onto the mounting plate, ensure
that the locking pin is put into the unlocked position. To unlock the
locking pin, push the locking pin to the left.
008546_001
6. Hold the CS field controller above the holder and lower the end of
the CS field controller into the mounting plate.
7. Apply slight pressure in a downward direction and then lower the top
part of the CS field controller until the unit is clicked into the holder.
The guides of the mounting plate aid in this action.
7b
7c
008547_001
GHT63 clamp
d
a
e
b
c
GHT66 holder
f
d
g
e
h
f
i
g
h
i
7a
Plastic sleeve
Pole clamp
Clamp bolt
Locking pin
Top clip
Mounting plate
Bottom clip
Tightening screw
Mounting arm
39