Fixing The Cs To A Holder And Pole - Leica Viva Series User Manual

4.1.5
Components of the
GHT62 holder
Fixing the CS field
controller and
GHT62 to a pole
step-by-step
GS25, Operation

Fixing the CS to a Holder and Pole

The GHT62 holder consists of some components, as shown in the diagram.
a
b
c
TS_058
Step Description

If you use the CS15 field controller, extend the mounting plate of the holder
first.

For an aluminium pole, fit the plastic sleeve to the pole clamp.
1. Insert the pole into the clamp hole.
2. Attach the holder to the clamp using the clamp bolt.
3. Adjust the angle and the height of the holder on the pole to a comfortable
position.
4. Tighten the clamp with the clamp bolt.
5. Before the CS field controller is
placed onto the mounting plate,
ensure that the locking pin is put
into the unlocked position. To
unlock the locking pin, push the
locking pin to the left.
6. Hold the CS field controller above the holder and lower the end of the CS
field controller into the mounting plate.
7. Apply slight pressure in a downward direction and then
lower the top part of the CS field controller until the unit
is clicked into the holder. The guides of the mounting plate
aid in this action.
GHT63 clamp
d
a) Plastic sleeve
e
b) Pole clamp
c) Clamp bolt
GHT62 holder
f
d) Locking pin
g
e) Top clip
h f) Mounting plate (extendable)
g) Bottom clip
i
h) Tightening screw
i) Mounting arm
TS_055
TS_056
32