Table of Contents
Advertisement
Blown Fuses
If the fuse appears to have blown during operation, this instrument may be subject to
failure and must be repaired. Ship the E5070A/E5071A to the nearest Agilent Technologies
Service Center by seeing Section "Considerations When Shipping to a Service Center Due
to Breakdown or Other Problem" on page 36
The E5070A/E5071A uses the following fuse type: UL/CSA Type, Slo-Blo, 8 A/250 Vac
WARNING
Do NOT replace the fuse yourself; doing this may expose you to dangerous electrical
shock.
Starting the E5070A/E5071A
This section describes how to turn on/off the E5070A/E5071A power, how to cut off the
power supply in an emergency, and how to set the internal clock.
Turning the Power ON and OFF
Perform the following steps to turn the power ON or OFF.
Turning the Power ON
Step 1. If the standby switch (
(
Step 2. Press the standby switch to put it in the depressed position (
This operation turns ON the power, and the E5070A/E5071A starts the self-test.
Step 3. Confirm that the self-test indicates normal operation.
Normal operation is confirmed by the self-test if no error message appears.
Chapter 2
) in the lower-left part of the front panel is in the depressed
) position, press it to put it in the popped up position (
Installation
Starting the E5070A/E5071A
).
).
31
Advertisement
Table of Contents
