Table of Contents
Advertisement
Installation
Starting the E5070A/E5071A
Turning the Power OFF
Step 1. Use either of the following methods to turn the power OFF.
•
•
These operations will start the E5070A/E5071A shutdown process (required software and
hardware processes for turning the power off), and the power will turn OFF after a few
seconds.
NOTE
Under normal circumstances, always press the standby switch (
command from an external controller, to execute the E5070A/E5071A shutdown process.
Never cut off the power supply directly by disconnecting the power cable plug from
the rear panel of the unit.
If the power supply is cut off directly by disconnecting the power cable plug from the
instrument or the AC outlet, the shutdown process is not carried out and there is a risk of
damage to the E5070A/E5071A's software or hardware.
Figure 2-11
Line switch (Always ON) and power cable receptacle
32
Press the standby switch (
pressed down (
) position) to put it in the popped up (
Send the shutdown command from an external controller.
) in the lower-left part of the front panel (now in the
) position.
), or send the shutdown
Chapter 2
Advertisement
Table of Contents
