Disconnection From Supply Source; Disconnection From Supply Source; Setting The Internal Clock; Disconnecting Device - Agilent Technologies E5070A ENA Series Installation And Quick Start Manual

Disconnection from Supply Source

The power supply of the E5070A/E5071A is cut off by disconnecting the plug of the power
cable (on either AC outlet side or E5070A/E5071A side). When it is necessary to
disconnect the power supply in order to avoid shock hazards, etc., pull out the power cable
plug from either the AC outlet side or the E5070A/E5071A side.
NOTE To allow this operation to be performed smoothly, be sure to follow the guidelines in
"Ensuring Adequate Free Space around Analyzer for Immediate Disconnection of Power
Cable in Case of Emergency" on page 20.
When turning the power OFF under normal circumstances, always follow the methods
described in "Turning the Power OFF" on page 32.

Setting the Internal Clock

You can set the date/time displayed at the lower right of the screen. When you save data in
the storage unit, for example, the internal clock data will be used. The following describes
the setting procedure that uses keys on the front panel.
NOTE When turning on the instrument power for the first time after delivery, always be sure to set
the internal clock.

Setting the Date/Time

Step 1. Press the
focus to the
key to move the focus to the
Point the focus to the
Properties dialog box will appear (Figure 2-12).
Figure 2-12 Date/Time Properties Dialog Box ("Date & Time" Tab)
Chapter 2
key in the INSTR STATE block. Press the
[System]
button and then press the
Misc Setup
Clock Setup
Set Date and Time
Starting the E5070A/E5071A
or
[¯] [­]
or key. Press the
[Enter] [®]
button and then press the
[Enter]
button and press the key. The Date/Time
[Enter]
Installation
key to move the
or
[¯] [­]
or key.
[®]
33