Identifying The Device Type During Phone Boot-Up - Avaya J169 Manual

Getting Started
• Never: To never prompt for the provisioning server address.
• Cancel: To cancel the prompt and display the Login screen.
3. After you have pressed Config, enter the provisioning server address in the Address field.
The address is an alphanumeric URL like http://myfileserver.com/j100/.
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric soft key to toggle to the
ABC mode.
To enter the forward slash symbol (/) in the field, press the / soft key.
4. (Optional) Enter the Group number.
Obtain the Group number from your system administrator. The value ranges from 0 to 999.
0 is the default value. If you do not enter any value in this field, the phone uses the default
value.
5. Press Save.
The phone continues to boot and connect to the provisioning server address for
provisioning configuration.
Related links
Setting Up the Avaya J179 IP Phone

Identifying the device type during phone boot-up

About this task
Avaya J100 Series IP Phones screen displays the device type during the phone boot-up. This
feature is supported only in the phone software version 4.0.3 and later.
Procedure
1. Set up the phone hardware.
2. Plug the Ethernet cable to the phone.
The phone powers up and starts to initialize.
The phone primary screen displays one of the following as the backsplash screen:
• A screen with Avaya text for Avaya SIP phones
• A screen with Open SIP text for Open SIP phones
April 2021 Using Avaya J169 and J179 SIP IP Phones in Open SIP
Comments on this document? infodev@avaya.com
22