SunStar NNS Series User Manual page 75

5.4.1) Position
This function is to set the desired position to begin embroidery.
(1) Frame Origin
① When the frame origin button is pressed, the frame will automatically move to the origin. That is,
when seeing the embroidery machine from the front, the frame will move to the very left and very
front place to fi nd the origin, and returns to the point where this function started. During the time
it carries out this function, it will stop moving the frame when the "Stop" button is pressed. If you
want to keep moving the frame to fi nd the origin, press "Start" button. If you press "Cancel" button
in the state that it is stopped by pressing "Stop" button, the frame will not seek the origin any more
and stay still.
Caution
Since the frame moves to fi nd the origin, it might strike objects if they are placed on the table,
and they might damage the frame. Therefore, please make sure that you do not place any objects
on the table during embroidery.
② Dotted line in the frame is the maximum size along the horizontal and vertical lines for the
embroidery design. '+' mark in the dotted line is the embroidery starting point and simultaneously
indicates the frame position where the current needle will embroider.
③ If you press the spot in the frame that you want, the embroidery design will move to the frame
position spotted. If there is red-colored part in the dotted line showing the embroidery design, X, Y
limit error would occur. Therefore, you should select the place where the whole dotted line is dis-
played within the frame.
Caution
The origin of the frame is twisted in case that the frame is moved by hand when the main power
is off. When the frame origin is moved like this, the correct position cannot be adjusted using the
position function.
(2) Trace
This function is to briefl y check whether the design size goes beyond the X, Y limits, if the embroi-
dery of chose design begins from the current frame position. While the frame moves fast between the
maximum X, Y range, the function checks whether the design goes beyond the frame limits. If so, the
frame operation will be stopped, and the message "Frame Limit Error" will appear on the screen.
① If you press "Trace" button, "Move Frame" button will be enabled.
② If you press "Move Frame" button, the frame will start moving to check the design work range
in the hoop set. During the time it carries out this function, it will stop moving the frame when the
"Stop" button is pressed. If you want to keep moving the frame to trace, press "Start" button. If you
press "Cancel" button in the state that it is stopped by pressing "Stop" button, the frame will not trace
any more and go back to the design starting point.
73