Table of Contents
Advertisement
(4) Presser Foot Height Setting (※ Only available for DM type machines)
This sets the height of the each needle set. When the needle is changed during the actual embroidery
work, the entered height of the corresponding needle is automatically applied. This is available only
for the DM type machines.
<How to set>
① Press "Presser Foot Height" button at the bottom of the setting screen.
② The screen will shift for the presser foot height setting as the <Fig. 5.3.4-6>.
③ Press 1
step input column.
st
④ After selecting the height that you want at the bottom of the screen using the arrow keys, press
"OK" button.
⑤ When it moves to the 2
and press "OK" button.
⑥ If you would like to apply the same height for all the needles, select the height you want in the
height input column and press "All" check box on the right.
⑦ Entering all the heights for all the needles, you can press "X" button on the top right to fi nish the
setting returning back to the previous screen.
<Fig.5.3.4-6>
step input column automatically, select the height that you want likewise,
nd
64
Advertisement
Table of Contents
