Environmental Compliance; Industry Canada (Ic) - Viavi SmartClass OLP-85 Series Operating Manual

13
E
NVIRONMENTAL
NOTE:
NOTE:
NOTE:
OLP-85/OLP-85P
C
This equipment was tested and found to comply with EN61326-
1, IEC 61000-4-2, IEC61000-4-3, IEC/CISPR11. The limits are
designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to
cause harmful interference, in which case you will be required to
correct the interference at your own expense.
The authority to operate this equipment is conditioned by the
requirements that no modifications be made to the equipment
unless the changes or modifications are expressly approved by
Viavi.
To comply with FCC RF exposure compliance requirements, a
separation distance of at least 20 cm must be maintained
between the antenna of this device and all persons.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

Industry Canada (IC)

This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
1) This device may not cause interference;
2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Device operation in the band 5150-5250 MHz is for indoor use
only.
13 E
OMPLIANCE
C
NVIRONMENTAL OMPLIANCE
I C (IC)
NDUSTRY ANADA
73