Viavi SmartClass OLP-85 Series Operating Manual page 54

8 P /PCM O
ROBE PERATION
C D
ONFIGURING THE IGITAL
54
P
ROBE
To launch the test with the predefined profile (see
on page 56):
1. With the P5000i Digital Probe, use the Focus Control key (see
Fig. 17) to adjust the image quality and sharpness.
[A]
2. Press the key and tap the
– or –
Press the QuickCapture™ key on the Digital Probe if the button
action is set to Test.
When the test procedure terminates, the information shown on
the display depends on the current overlay setting:
[A]
Press the key and then the
J
the overlay view. Repeat the action until the desired view
appears.
Three views can be displayed: without overlay, with colored
edges, and colored edges with a legend.
Overlay
A summary of test results is displayed at the upper right of the
screen.
• Zone A: Represents the core zone.
It is the area surrounding the core.
• Zone B: Represents the cladding zone.
It surrounds the majority of the fiber
cladding.
• Zone C: Represents the epoxy ring.
• Zone D: Represents the ferrule zone.
It identifies a portion of the ferrule
near and around the fiber.
[Test] button.
[Overlay] button to change
Zone D
Zone C
.
Zone B
Zone A
OLP-85/OLP-85P
"Profile"