Viavi SmartClass OLP-85 Series Operating Manual page 31

NOTE:
NOTE:
OLP-85/OLP-85P
To set 24-hour or 12-hour time:
1. Tap [Time Format].
2. Select the desired time format.
Setting the Ethernet protocol
In the menu tap the
J
then tap [Ethernet].
To select the IP mode:
1. Tap the [IP Mode]
2. Select the desired Ethernet mode.
To set the IP address:
The IP mode Static is selected.
I
1. Tap [IP Address].
2. Type in the desired IP address.
3. Tap [OK].
To set the gateway:
The IP mode Static is selected.
I
1. Tap [Gateway].
2. Type in the desired gateway.
3. Tap [OK].
To set the netmask :
The IP mode Static is selected.
I
1. Tap [Netmask].
2. Type in the desired netmask.
3. Tap [OK].
Calibrating the touchscreen
Using a pen when calibrating the touchscreen will improve the
calibration accuracy.
1. In the menu tap the
then tap [Touchscreen calibration].
2. Follow the given instructions.
Resetting to the factory default values
Setting the factory default values does not affect your stored
measurement results.
[More] button,
button.
[More] button,
4 B O
ASIC PERATION
C S S
HANGING YSTEM ETTINGS
31