3M DBI-SALA Nano-Lok 3101521 User Instruction Manual page 17

7.2 DISPOSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For additional information on how to remove the RFID Tag, please refer to the website link below.
Do not dispose of your product as unsorted municipal waste. The crossed-out wheelie bin symbol indicates that
all EEE (Electrical and Electronic Equipment) must be disposed of according to local law through available return
and collection systems. Please contact your dealer or your local 3M representative for further information.
For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0 Labels
Figure 20 illustrates labels on the the Self-Retracting Devices and their locations. All labels must be present on the SRD. Labels
must be replaced if they are not fully legible. Pictograms on the labels are defined as follows:
Read Instructions.
Inspect Snap Hook and Impact Indicator
1
Inspect locking action of SRD
2
Correct way of connecting SRD to Harness
3
Not sharp edge certified. May be connected to an anchorage point above, below, or level with the dorsal D-ring (140 kg maximum).
4
Temperature Usage Range -40°C – +60°C
5
Maximum Capacity 140 kg
6
Always Allow the Lifeline to Recoil Back Into The SRD Under Control
7
Do Not Repair
8
Store in a cool, dry, clean environment; out of direct sunlight.
9
Do Not Load Over an Edge
10
Do Not Remove Label
11
17