Advertisement
Operating Procedure/Photos
Remove gas and liquid valves
Unsolder the pipelines connected with the valve (avoid the
welding gun burn out the chassis). Twist off the 2 bolts used
for fixing the gas valve, unsolder the soldering joint between
pipeline and gas valve and then remove the gas valve. Twist
off the 2 bolts used for fixing the liquid valve, unsolder the
soldering joint between pipeline and liquid valve and then
remove the liquid valve. (Note: when unsoldering the
soldering joint, wrap the valve with wet cloth completely to
avoid the damaged of valve due to high temperature). As
shown in fig 7-29
Remove axial flow blade
Twist off the nuts on blade with wrench and then remove the
blade. As shown in fig 7-30.
Remove outdoor motor
Twist off the screws used for fixing the motor support, pull it
upward and then remove the motor support. Twist off the
screws used for fixing the motor, pull out the connection wire
between motor and electric box and then remove the motor.
As shown in fig 7-31
liquid valve bolt
motor
fixing screw of motor
motor support
fixing screw
Admiral Series
gas valve
Fig.
axial flow blade
nut
Fig.
Fig.
Advertisement
