Advertisement
Operating Procedure/Photos
Remove electric box
Twist off the 3 screws used for fixing the mounting plate, pull
out the pin of lead-out wire for compressor and fan motor and
then remove the mounting plate. As shown in fig 7-16.
Remove right side plate
Twist off the 5 screws at the right side plate to remove it. As
shown in fig 7-17.
Remove axial flow blade
Loosen the fixing nuts with wrench and then remove the nuts,
spring shim, flat shim and then remove the axial flow blade.
As shown in fig 7-18.
screw
fixing nut
axial flow blade
mounting plate
screw
Fig.
Fig.
Fig.
Advertisement
