Advertisement
Operating Procedure/Photos
Remove axial flow blade
Remove the nuts on blade with wrench and then remove the
axial flow blade. As shown in fig 7-41
Remove outdoor motor
Twist off the 4 tapping screws used for fixing the motor, pull
out the pin of lead-out wire for motor and then remove the
motor. Twist off the 2 tapping screws used for fixing the motor
support, pull it upward and then remove the motor support.
As shown in fig 7-42
Remove 4-way valve
Twist off the fixing nut on 4-way valve coil and then remove
the coil. Wrap the 4-way valve with wet cloth, unsolder the 4
soldering joint connected with the 4-way valve and then
remove the 4-way valve. The welding process should be as
soon as possible and please the cloth wet all the time. Do not
let the welding flame burn out the lead-out wire of
compressor. As shown in fig 7-43
fixing nut
axial blade
motor
fixing screw for motor
motor wire
motor support
fixing screw
4-way valve
soldering spot
Admiral Series
Fig.
Fig.
Fig.
Advertisement
