Parameter List - Siemens Sinamics V90 Operating Instructions Manual

10.2

Parameter list

Editable parameters
The values of the parameters marked with an asterisk (*) may be changed after
commissioning. Make sure you back up the parameters first as required if you desire to
replace the motor. The default values of the parameters marked with two asterisks (**) are
motor dependent. They may have different default values when different motors are
connected.
Par. No. Name
p0748 CU invert digital outputs
Description: Inverts the signals at the digital outputs.
Bit 0 to bit 5: invert signal for DO 1 to DO 6.
•
– Bit = 0: not inverted
– Bit = 1: inverted
p0795 Digital inputs simulation
mode
Description: Sets the simulation mode for digital inputs.
Bit 0 to bit 9: set the simulation mode for DI 1 to DI 10
•
– Bit = 0: terminal eval
– Bit = 1: simulation
Note: If a digital input is used as signal source for the function "STO" then it is not permissible to select the
simulation mode and this is rejected.
This parameter is not saved when data is backed up.
p0796 Digital inputs simulation
mode setpoint
Description: Sets the setpoint for the input signals in the digital input simulation mode.
Bit 0 to bit 9: set the setpoint for DI 1 to DI 10
•
– Bit = 0: low
– Bit = 1: high
Note: This parameter is not saved when data is backed up.
p0927 Parameter authority
Description: Sets the interface via which parameters can be changed.
Bit definition:
•
– Bit 0: V-ASSISTANT
– Bit 1: BOP
Value definition for a bit:
•
– 0: read only
– 1: read and write
Note: If p927.0 = 0, the V-ASSISTANT can only be used to read parameters, all other functions won't work.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
Min Max
0 63
1 429496729
5
1 429496729
5
0000 bin 0011 bin
Factory Unit Data
Setting type
0 - U32
0 - U32
0 - U32
0011 - U16
bin
Parameters
10.2 Parameter list
Effective Can be
changed
IM T, U
IM T, U
IM T, U
IM T
343