Siemens Sinamics V90 Operating Instructions Manual page 192

Basic operator panel (BOP)
6.1 BOP overview
Display Example
P xxx
Data
Func
Jog
Save
defu
dr--sd
sd--dr
Update
A OFF1
A OFF2
ABS
A.B.S.
r xxx
r -xxx
T x.x
xxxxxx
xxxxxx.
T -x.x
190
Description
Parameter group
Read-only parameter group
Function group
Jog function
Save data in drive
Restore drive to default settings
Save data from drive to micro SD
card/SD card
Upload data from micro SD
card/SD card to drive
Update firmware
Adjust AI1 offset
Adjust AI2 offset
The zero position has not been set
The zero position has been set
Actual speed (positive direction)
Actual speed (negative direction)
Actual torque (positive direction)
Actual position (positive direction)
Actual position (negative direction)
Actual torque (negative direction)
Remarks
Six groups are available:
1. P 0A: basic
2. P 0B: gain adjustment
3. P 0C: speed control
4. P 0D: torque control
5. P 0E: position control
6. P 0F: I/O
7. P ALL: all parameters
Refer to "Viewing parameters (Page 198)".
Refer to "Auxiliary functions (Page 199)".
Refer to "JOG (Page 200)".
Refer to "Saving parameters (RAM to ROM)
(Page 201)".
Refer to "Setting parameters to default
(Page 202)".
Refer to "Transferring data (drive to SD)
(Page 203)".
Refer to "Transferring data (SD to drive)
(Page 203)".
Refer to "Updating firmware (Page 204)".
Refer to "Adjusting AI offsets (Page 205)".
Refer to "Adjusting AI offsets (Page 205)".
Refer to "Adjusting an absolute encoder
(Page 207)".
Refer to "Adjusting an absolute encoder
(Page 207)".
Only the last six digits displays due to a lim-
ited display length.
Only the last six digits displays due to a lim-
ited display length.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007