Index - Siemens Sinamics V90 Operating Instructions Manual
Pulse train, uss/modbus interface
Hide thumbs
Also See for Sinamics V90:
- Operating instructions manual (364 pages) ,
- Operating manual (158 pages) ,
- Getting started (116 pages)
Table of Contents
Advertisement
Index
A
Accessories
Braking resistor, 51
External 24 V DC power supply, 49
Filter, 52
Fuse/Type-E combination motor controller, 50
MOTION-CONNECT 300 cable and connector, 47
Replacement fans, 58
SD card/Micro SD card, 58
Setpoint cable, 48
Adjust AI offset, 205
Aims, 293
analog inputs, 133
Analog inputs
Command voltage, 134
analog outputs, 134
Analog outputs
Parameterization, 134
Wiring, 135
ANSI B11, 304
B
Backlash compensation, 240
BOP operations
Button functions, 192
BOP operations for faults and alarms, 385
Acknowledging faults, 386
Exiting from alarm display, 385
Exiting from fault display, 385
Viewing alarms, 385
Viewing faults, 385
BOP overview, 187
C
Certification, 306
Change a parameter value, 196
Parameter setting with shift function, 197
Commissioning
Initial commissioning, 176
Connecting 24 V power supply/STO, 162
Connecting an external braking resistor, 168
Connecting the cable shields, 111
Connecting the RS485 interface, 174
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
Connecting the SIMATIC S7-1200
For fast pulse train input position control (Fast
PTI), 158
For internal position control (IPos), 159
For pulse train input position control (PTI), 157
For speed control (S), 160
For torque control (T), 161
Connecting the SIMATIC S7-200
For fast pulse train input position control (Fast
PTI), 153
For internal position control (IPos), 154
For pulse train input position control (PTI), 152
For speed control, 155
For torque control, 156
Connecting the SIMATIC S7-200 SMART
For fast pulse train input position control (Fast
PTI), 148
For internal position control (IPos), 149
For pulse train input position control (PTI), 146
For speed control (S), 150
For torque control (T), 151
Copy parameter set from a micro SD card/SD card to
drive, 203
Copy parameters from the servo drive to a micro SD
card/SD card, 203
D
Differences between faults and alarms, 384
Digital inputs, 123
Direct signal map, 126
Wiring, 127
Digital outputs, 128
Assigning warning signals to digital outputs, 130
DIN EN ISO 13849-1, 297
Direction of motor rotation, 212
Drive overload capacity
300% overload capacity, 213
Drive rating plate, 27
E
EN 61508, 299
EN 62061, 298
Equipment regulations, 305
427
Advertisement
Table of Contents
