D-Link DAP-300P User Manual page 18

DAP-300P Wireless N300 PoE Access Point / Router
User Manual
10. On the opened page, enter the IP address of the access point (by default, the following IP
address is specified: 192.168.0.50) in the device URL address field and click the button
to confirm (
11. Make sure that the application correctly identified the access point to which you connect,
and click the Open button to configure all needed parameters of DAP-300P.
You can go through the Initial Configuration Wizard or finish the Wizard earlier and go the
configuration menu (for the description of the configuration pages, see the relevant section of the
Configuring via Web-based Interface chapter).
As you perform initial configuration of the access point via Wi-Fi connection, note that
!
immediately after changing the wireless default settings of the access point you will need
to reconfigure the wireless connection using the newly specified settings.
When DAP-300P is accessed with the application the next time and after, the authorization page
opens. Enter the username (admin) and the password you specified.
).
Figure 5. The device URL settings page.
Page 18 of 175
Installation and Connection