Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
PC with Wi-Fi Adapter
1. For a switch supporting PoE: connect an Ethernet cable between the PoE-enabled switch
and the WAN port of the access point.
2. For a switch not supporting PoE or router: connect an Ethernet cable between the switch
or router and any Ethernet port of the access point.
3. Connect the power adapter (not included in the delivery package) to the power connector
port on the back panel of the access point, then plug the power adapter into an electrical
outlet or power strip.
4. Make sure that the Wi-Fi adapter of your PC is on. As a rule, modern notebooks with built-
in wireless NICs are equipped with a button or switch that turns on/off the wireless adapter
(refer to your PC documents). If your PC is equipped with a pluggable wireless NIC, install
the software provided with your Wi-Fi adapter.
Now you should configure your Wi-Fi adapter.
Page 29 of 175
Installation and Connection
Advertisement
Table of Contents
