Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Parameter
The contact information
for the administrator
System location
After specifying the needed parameters, click the APPLY button.
In order to disable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the left and click the APPLY button.
If the SNMP manager operates over SNMPv2c, create a read-only community which will be used
by the SNMP manager to get data on the device. To do this, in the Communities section, click the
ADD button and specify the community name in the line displayed. Then click the APPLY button.
To remove a community, click the Delete icon ( ) in the relevant line. Then click the APPLY
button.
If the SNMP manager operates over SNMPv3, create a read-only user which will be used by the
SNMP manager to get data on the device. To do this, in the Users section, click the ADD
button (
).
Additional information used to contact the administrator of the
access point.
Additional information used to locate the access point.
Figure 97. The window for adding a user.
Page 115 of 175
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
