Related Manuals for D-Link AirPremier N DAP-3525
Summary of Contents for D-Link AirPremier N DAP-3525
- Page 1 Quick Install Guide DAP-3525 ® Dual Band Exterior PoE Access Point B u s i n e s s C l a s s N e t w o r k i n g...
-
Page 2: System Requirements
• Grounding Wire • Mounting Screws Ethernet Port LAN LED A sold green light indicates the Ethernet Connects DAP-3525 to the network connection is good. The light will blink via Ethernet cable. during data transmission. Reset Button Resets the Access Point to factory... - Page 3 Welcome to D-Link’s line of cloud-managed wireless Access Points. Leverage the product’s online interface to configure, deploy, secure and manage your entire wireless network. Registering Your Access Point Online Step 1: Before you can use the Access Point, you must register it online.
- Page 4 Access Point to a static IP address using the CloudCommand™ interface . The DAP-3525 is PoE ( Power over Ethernet ) compliant. You can power it either by using a PoE switch or the included power adapter. Once powered, the green power LED will turn ON to indicate proper operation.
- Page 5 ), follow these steps to properly configure your Access Point: Configure APs Step 1: Connect the Access Point directly to your computer using an Ethernet cable. DAP-3525 PC or Mac Step 2: Configure the Ethernet connection of your computer as follows: Windows 7 - Click on Start >...
- Page 6 (default - 192.168.0.50) or the default device name of the access point (http://dlinkapxxxx where xxxx are the last 4 numbers of the MAC address). The MAC Address is on the lower-left corner of the device label (highlighted below). DAP-3525 CCAXXXXXXXXXXX FCC ID: KA2AP3520A1 IC: 4216A-AP3525A1...
- Page 7 Access Point to a new static IP address using the CloudCommand™ interface. The DAP-3525 is PoE ( Power over Ethernet ) compliant. You can power it either by using a PoE switch or the included power adapter. Once powered, the green power LED will turn ON to indicate proper operation.
- Page 8 CloudCommand™ Dashboard To view your CloudCommand™ dashboard, please log in at http://dlink.cloudcommand.com. The dashboard is your starting point to monitor network activity, troubleshoot problems, authorize and disconnect individual devices, or make configuration changes to your Access Point(s). Manage Access Points and connected View devices connected to your devices primary wireless network...
-
Page 9: Installation / Mounting
This product should ONLY be installed by an experienced installer who is familliar with local building and safety codes and where ever applicable, is licensed by the appropriate authorities. Failure to do so may void the D-Link product warranty and may expose the end user or the service provider to legal and financial liabilities. -
Page 10: Attach The Mounting Plate
Step 2: After plugging the Ethernet cable in the port, tighten the waterproof enclosure. Step 3: Attach the grounding cable and tighten the screw. Attach the Mounting Plate Step 1: Insert provided wall anchors in the wall where the mounting plate will be attached. - Page 11 Step 2: Attach the remaining screws securely to the back of the DAP-3525. Step 3: Attach the DAP-3525 to the mounting plate. Step 4: Slide the DAP-3525 down into the grooves on the mounting plate to secure it to the plate.
-
Page 12: Technical Support
Copyright ©2011 D-Link Corporation/D-Link Systems, Inc. All rights reserved. D-Link and the D-Link logo are registered trademarks of D-Link Corporation or its subsidiaries in the United States and other countries. CloudCommand™ is a trademark of PowerCloud™ Systems, Inc. All rights reserved.