D-Link DAP-300P User Manual page 144

DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Parameter
Action
Protocol
IP version
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Select an action for the rule.
•
Allow: Allows packet transmission in accordance with the
criteria specified by the rule.
•
Deny: Denies packet transmission in accordance with the
criteria specified by the rule.
A protocol for network packet transmission. Select a value from the
drop-down list.
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
Source IP address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the access point's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP address
Select the needed value from the drop-down list.
The destination host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the access point's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The destination host end IPv4 or IPv6 address.
The destination subnet IPv4 or IPv6 address. The field is displayed
when the Subnet value is selected from the Set as drop-down list.
Page 144 of 175
Configuring via Web-based Interface
Description