Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Figure 101. The window for changing the settings of the access point's port.
In the opened window, specify the needed parameters:
Parameter
Speed
To enable the needed data transfer modes, move relevant switches to the right.
Data transfer mode.
Select the
Auto
value to enable autonegotiation.
selected, the Autonegotiation Modes and Flow сontrol sections
are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
•
10M-Half: Data transfer in just
can be
either sent or
of up to 10Mbps.
•
10M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
•
100M-Half: Data transfer in just
can be
either sent or
of up to
100Mbps.
•
100M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
Autonegotiation Modes
Page 120 of 175
Configuring via Web-based Interface
Description
one direction at a time
received) at the maximum possible
rate
of up to
10Mbps.
one direction at a time
received)
at the maximum possible
rate
of up to
100Mbps.
When this value is
(data
rate
at the
(data
rate
at the
Advertisement
Table of Contents
