Back Panel - D-Link DAP-300P User Manual

DAP-300P Wireless N300 PoE Access Point / Router
User Manual

Back Panel

Name
RESET
LAN
WAN (PoE)
Also, the power connector is located on the back panel of the access point. The device is also
equipped with two internal Wi-Fi antennas.
Figure 2. Back panel view.
A button to restore the factory defaults.
To restore the factory defaults, push the button (with the device turned on),
hold it for 10 seconds, and then release the button.
An Ethernet port to connect a computer or network device.
A LAN LED corresponds to the port. The operating modes:
Solid green
Blinking green
No light
A port with PoE support to connect
cable or DSL modem. In the access point mode, it is used as the LAN port.
An INTERNET LED corresponds to the port. The operating modes:
Solid green
Blinking green
No light
Page 12 of 175
Description
A device (computer) is connected to the port,
the connection is on.
Data transfer through the LAN port.
The cable is not connected to the port.
to a switch, a private Ethernet line, or a
The cable is connected to the port.
Data transfer through the WAN port.
The cable is not connected.
Overview