Installing The Lens - Christie CP4315-RGB Installation And Setup Manual

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off the projector and the circuit breaker switches.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
2. Position the lens so that the UP label is facing upward.
3. Turn the clamp on the lens mount to the open position.
4. Fully insert the lens into the lens mount opening without turning, until it reaches the stop
position.
5. Connect the lens zoom motor to the two zoom motor harness connectors.
6. Lock the lens assembly in place by rotating the lens clamp downward.
Cinema 4K-RGB Installation and Setup Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102710-08 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
28