Table of Contents
Advertisement
Bennett Pacific eNVy Series Installation Manual
Shear Valve Installation (Remote Dispensers)
DANGER:
IMPACT SAFETY VALVES ARE TO BE INSTALLED WITH SHEAR SECTION IN LINE WITH THE
SURFACE OF THE ISLAND WITHIN + ¾" DEPENDING ON THE VALVE TO BE USED. A
LONGER OR SHORTER INLET NIPPLE MAY BE REQUIRED.
Install an approved emergency shear valve, designed to close automatically in the event of a severe impact or fire
exposure, in the dispenser supply line at the base of the dispenser. The valve will also permit safe inspection and
maintenance. Note: If the shear valve is not properly attached, it may not operate correctly in the event of a severe
impact or fire exposure. Follow the manufactures installation instructions for the approved emergency shear valve
being installed as shown in Figure 7.
Determining Stub Up Positions in the Containment Sump
Determine the model number of the dispenser or pump from the pump's serial tag and locate the corresponding
configuration from the product supply diagrams on pages 7 through 9. The exact inlet and conduit connections for
the dispenser locations can be found using the footprint diagrams on pages 15 through 18. Use these prints to plan
your installation accordingly.
General Installation
Figure 6 - Dispenser Containment Sump
Figure 7 – Shear Valve Installation
12
General Installation
Advertisement
Table of Contents
