Instructions For The Installer; Storage; Transportation Of The Appliance; Unpacking The Appliance - eka MILLENIAL MKF 464 TS Installation And Maintenance Manual

Electronic ovens with touch screen
Table of Contents

Advertisement

3. Instructions for the installer

The following instructions are intended for skilled installers, to perform installation, electrical and water
connection operations in the most correct manner and according to the safety regulations in force in the
country of installation of the appliance.
The Manufacturing Company shall not be liable for damage or harm to persons, pets or property arising
from installation errors. Nor are they responsible for any appliance breakage caused by faulty installation.

3.1 Storage

If the appliance is stored in a warehouse, the ambient temperature must never drop below 0°C. Before
switching on the appliance it must be brought to a temperature of at least +10°C.

3.2 Transportation of the appliance

During transportation the appliance must be left in its packaging in order to protect it from any external
damage.
The weight of the appliance must also be taken into account in order to prevent overturning.

3.3 Unpacking the appliance

Remove the packaging before installation. It consists of a wooden pallet supporting the appliance and a
cardboard casing protecting it. Ensure the appliance has not undergone any damage during transport;
otherwise immediately alert your dealer and/or carrier.

3.4 Removal of the protective film

Before using the appliance accurately remove the special film protecting the stainless steel components,
avoiding glue residues on the surfaces; if required, immediately remove them using an appropriate non
flammable solvent. Do not use any tools that might scratch the surfaces or any acid-based or abrasive
detergents.

3.5 Protective film/package disposal

The protective film and packaging must be disposed of in strict compliance with the regulations in force in
the country of installation of the appliance. The various materials (wood-paper-carton-nylon-metal tacks)
that may comprise the packaging are potentially dangerous, so children and animals must be kept away;
they must be duly separated and delivered to the respective collection centres. In any case please adhere to
the local environmental protection regulations.

3.6 Placement

Check the place of installation making sure that the transit areas (any doors and corridors) are sufficiently
wide and the floor supports the appliance weight (the appliance weight and its dimensions with/without
pallets are provided in the attached "Technical Data Sheet"). The appliance must be transported with
mechanical means (e.g. pallet jack). The installation rooms must be well-ventilated with permanent aeration
vents; must be equipped with the proper electrical and hydro systems, built in accordance with the standards
related to facilities and workplace safety in the country of installation.
The maximum working height, referring to the highest surface level, must be 1.6 metres from the floor.
After installing the appliance, if required, apply the suitable adhesive symbol
(supplied) at a height of
1.6 metres. To favour air circulation around the appliance, leave a space of about 10 cm between the
appliance sides and the surrounding walls (or other appliance), and between the back and the back wall (see
the attached "Technical Data Sheet"). The appliance must be positioned so that the rear wall is easily
accessible to set up various electrical connections and to carry out any possible maintenance. Do not install
the appliance near any equipment that may reach high temperature values (e.g. deep fryers).
Should the appliance be installed near walls, shelves, counters and the like, these must be non-flammable or
heat-resistant; otherwise, they must be protected by adequate fire retardant coating. Accordingly, it is
indispensable to act in compliance with the fire prevention regulations in force.
Cooking produces hot smoke/vapour and odours which are extracted through the suitable vent device
located at the top of the appliance and marked with the symbol
.It is recommended to place the
appliance under an extraction hood or to use the suitable
condensation hoods in order to convey
TECNOEKA.
the smoke/vapour to the outside.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents