Advertisement
_ TECNOEKA Srl __________________________________________________________ use and instruction manual _
1.2
1.2 Technical rating plate
1.2
1.2
Technical rating plate
Technical rating plate
Technical rating plate
Model:
KF 1010
KF 1010 EV
KF 1010
KF 1010
Voltage:
380/400V∼ 3N 50/60Hz
Oven capacity:
Max. capacity:
Water pressure:
Made in Italy
The Technical rating plate is fitted on the rear panel of the oven.
The Technical rating plate is fitted on the rear panel of the oven.
The Technical rating plate is fitted on the rear panel of the oven.
The Technical rating plate is fitted on the rear panel of the oven.
2 2 2 2 . . . . Instructions for the installer
Instructions for the installer
Instructions for the installer
Instructions for the installer
The following instructions are addressed to the qualified installer to enable him to perform
the correct installation, electric and water connection operations in conformity with current
safety legislation in force in the place where the appliance is installed.
The manufacturer will not respond for damage to people, animals and property due to
installation errors. Likewise the manufacturer is not responsible for breakage caused to the
appliance by incorrect installation.
2.1
2.1
2.1
2.1 Storage
Storage
Storage
Storage
If the appliance has been stored in a warehouse at a temperature below 0°C (min. allowed is
–10°C), it should be brought to a temperature of at least +10°C before it is turned on.
2.2
2.2
2.2
2.2 Transporting the oven
Transporting the oven
Transporting the oven
Transporting the oven
During transport, the appliance must be left in its original wooden cage to protect it against
damage.
2.3
2.3
2.3 Unpacking the oven
2.3
Unpacking the oven
Unpacking the oven
Unpacking the oven
Remove all the packaging before installation, which is formed of a wooden cage that holds
the appliance and cardboard casing to protect it. Check that the appliance has not been
damaged during transport and if any damage is discovered immediately inform your retailer
and/or the haulier.
2.4
2.4
2.4 Removing the protective film
2.4
Removing the protective film
Removing the protective film
Removing the protective film
Before using the appliance, carefully remove the special protective film over the stainless steel
parts, without leaving any glue residue on the surfaces. If necessary, remove the residue at once
with a suitable non-inflammable solvent (e.g. acetone).
2.5 Disposing of
2.5
Disposing of the packaging
the packaging
2.5
2.5
Disposing of
Disposing of
the packaging
the packaging
The packaging must be disposed of in accordance with current legislation in force in the
place where the appliance is installed. The various types of materials (wood – paper – cardboard
– nylon – metal staples) used for the packaging must be separated and delivered to the specific
waste disposal centres. In all circumstances the environmental protection regulations must be
strictly adhered to.
_ page 6 _________________________________________________________________________________________
Tecnoeka S.r.l., Via I. Nievo, 12/B
35012 Camposampiero (Padova)
ITALY
EV UD
EV
EV
UD
UD
UD
kW 15
kW 23,5
kPa 200
520310727
CERTIFICATION
SERIAL NO.
Advertisement
