Table of Contents
Advertisement
Do not use trays with sides higher than necessary: the sides form barriers that prevent hot air
circulation.
Preheat the oven every time before cooking to achieve top performance.
For cooking as consistently as possible, spread the food evenly in every tray taking into account
its size, layer or thickness.
Avoid adding salt to food in the cooking chamber.
To check correct progress of the cooking cycle use the chamber's internal lighting: avoid
uselessly opening the door, which causes wastes of energy and longer cooking times.
RESIDUAL RISKS
After baking open the door with caution, to avoid the violent outflow of heat which might cause burns.
During oven operation pay attention to hot areas of its outer surfaces (marked on the appliance).
Do not use the door handle to move the appliance (possible glass breakage).
The supporting bench must be able to withstand the weight of the machine and house it correctly.
The appliance is fitted with electrical parts and must never be washed with a water or steam jet.
The appliance is electrically connected: disconnect the power supply before performing any type of
cleaning.
To avoid incorrect connections of the appliance, the relevant electrical/water connections are
marked on the appliance by suitable identification plates.
1. TECHNICAL SERVICE
It is essential for this instruction manual to be stored together with the appliance for future referencing;
in the event of misplacing it, a copy must be obtained directly from the manufacturer.
This information has been prepared for your safety and that of others; therefore we kindly ask you to
read it carefully before installing and using the appliance.
For periodic maintenance checks and repairs, contact your nearest Technical Support Centre and only
use original spare parts. Failure to comply with this provision shall forfeit the warranty right.
All installation and commissioning operations must exclusively be performed by technically skilled
installers, in compliance with the instructions of the Manufacturer and in compliance with national
standards in force.
The "technical data" plate is located on the side panel of the appliance.
Note: The inappropriate or incorrect use of the appliance and failure to comply with installation rules shall
invalidate any liability by the Manufacturer.
2. INSTRUCTIONS FOR THE INSTALLER
The following instructions are intended for skilled installers, to perform installation, electrical and water
connection operations in the most correct manner and according to the safety regulations in force in the
country of installation of the appliance.
The Manufacturing Company shall not be liable for damage or harm to persons, pets or property arising
from installation errors. Nor are they responsible for any appliance breakage caused by faulty installation.
2.1 Storage
If the appliance is stored in a warehouse, the ambient temperature must never drop below 0°C. Before
switching on the appliance it must be brought to a temperature of
2.2 Transportation of the appliance
During transportation the appliance must be left in its packaging in order to protect it from any external
damage.
The weight of the appliance must also be taken into account in order to prevent overturning.
2.3 Unpacking the appliance
Remove the packaging before installation. It consists of a wooden pallet supporting the appliance and a
cardboard casing protecting it. Ensure the appliance has not undergone any damage during transport;
otherwise immediately alert your dealer and/or carrier.
5
at least +10°C.
Advertisement
Table of Contents
