Safety Thermal Devices; Electronic Circuit Protection - eka MILLENIAL MKF 464 TS Installation And Maintenance Manual

4.2 Safety thermal devices

The appliance is equipped with a (manually reset) safety thermostat, to protect against excessive and
hazardous overheating which might accidentally occur inside it. If the safety thermostat is activated, the
power supply to the appliance is cut off.
The safety thermostat is located at the back (bottom) of the appliance (see the attached "Technical Data
Sheet"); to reset it after it has tripped, unscrew the protective cap using an appropriate tool and press the
"reset" button all the way. Replace the protective cap so that it cannot be unscrewed without the use of a
tool.
The steam generator for the appliances that include it (versions ) is equipped with a
"V TS" and "V C TS"
(manually reset) thermostat for heating resistor overheating protection. If the safety thermostat is triggered,
the power supply to the heating resistor is cut off.
The safety thermostat is located near the steam generator and is accessed by removing the back of the
appliance; to reset it after it is triggered, press the "reset" button all the way.
Important
Safety thermostats should only be reactivated after eliminating the anomaly that caused them to trip. This
can only be done by a Service technician.

4.3 Electronic circuit protection

The electronic circuit of the microprocessor cards housed inside the "electronic component drawer" is
protected by fuses. If they "blow" they must be replaced with equivalent fuses with the same electrical and
dimensional characteristics.
Important
"Blown" fuses should only be replaced after eliminating the anomalies that caused them to blow. This can
only be done by a Service technician.
4.4 Replacing the cooking chamber gasket
The cooking chamber gasket has a rigid profile with retaining fins. This profile must be inserted in
the suitable perimeter seat on the "front" of the chamber.
To replace the seal, simply remove the used seat (pull tightly near the 4 corners) and, after cleaning
any impurities from the seat, insert the new gasket (to facilitate the assembly, it is recommended to
wet the profile of the gasket with soapy water).
4.5 Handle closure adjustment
Should the door handle not close properly, check and if required adjust the position of the "nose" (cross-
shaped) as follows:
with the oven door open, loosen the 2 screws the secure the "nose" support;
move the support vertically (upwards or downwards) and fasten it so that when the door is pushed with the
handle completely open (horizontal position), the "nose" can fit into the handle without rubbing.
after adjustment, with the door closed, the handle must be in a perfectly vertical position (the end portion of
the "nose" must be perfectly horizontal).
Warning
The door handle must only be adjusted after positioning the oven in a perfectly horizontal (levelled) way.
12