Disposal Of The Appliance/Packaging - eka MILLENIAL MKF 464 TS Installation And Maintenance Manual

4.6 Checking the cooking chamber gasket "seal"
If the gasket on the "front" of the cooking chamber does not ensure proper "sealing" on the inside glass of
the door, adjust the position of the 2 hinges (upper and lower) of the door and/or the (cross-shaped) handle
"nose" projection by doing the following:
Loss of "tightness" on the hinges side
with the door closed, loosen the 6 screws securing the lower (3 screws) and upper (3 screws) hinges of the
door;
push the door slightly to the side of the hinges so that the inner glass leans on the "front" gasket; hold the
door slightly pressed in the direction of the hinges and secure them by screwing on the 6 previously
loosened screws. At the end of the operation, visually check, on the hinged side, that the door is perfectly
parallel to the "front" of the cooking chamber.
Loss of "tightness" on the "nose" side
with the door open, loosen the locknut that secures the "nose" to its support; screw (clockwise) the "nose"
by a full turn so that the end (cross-shaped) piece is perfectly horizontal again; screw on the previously
loosened locknut. At the end of the operation, close the door, and check for slight resistance when turning
the handle: this means that the "front" gasket is pressing ("sealing") slightly on the inside glass of the door.
If you do not feel any resistance, repeat the entire operation by screwing on the "nose" another full turn.
Warning
After performing all the operations necessary to restore the proper "sealing" of the gasket on the inside
glass of the door, check its tightness by running the oven: for at least 30 minutes, with a 100%
humidification cycle and with a cooking chamber temperature of 110°C. During oven operation no steam
must escape from the door.
4.7 Residual risks
Do not use the door handle to move the appliance: this may deform the door frame.
The appliance is fitted with electrical parts: it must never be washed with water or steam spray.
The appliance is electrically connected: disconnect the power supply before performing any type of
maintenance.
To avoid incorrect connections of the appliance, the relevant electrical/water connections are
marked on the appliance by suitable identification plates.
Only for wheeled models
(MKF 1664 TS – MKF 2011 TS)
After installing the oven, ensure the tray trolley can be handled with ease, on smooth floors and
with no hindrance to insertion and extraction operations: the trolley is mounted on wheels, any
collision may cause the hot cooking food and/or liquids to spill and may even cause it to tip over.

4.8 Disposal of the appliance/packaging

The appliance is made of recyclable raw materials and does not contain any substances that are toxic or
hazardous to man and the environment. The ultimate disposal of the appliance and its packaging must be
carried out strictly following the regulations in force in the country of installation. The different materials it is
made up of must be separated by type and delivered to the suitable collection centres. Always adhere to the
environmental protection regulations.
13