Technical Rating Plate; Instructions For The Installer; Storage; Transporting The Oven - eka EKF 1111 E UD Use And Instruction Manual

TECNOEKA Srl ______________________________________________________________ use and instruction manual

1.2 Technical rating plate

1.2 Technical rating plate
1.2 1.2 Technical rating plate Technical rating plate
Model: E E E E KF
Voltage: 380-400V 3N 50/60 Hz
Oven capacity:
Max. capacity:
Water pressure:
Made in Italy
The Technical rating plate is The Technical rating plate is fitted on the rear panel of the oven. The Technical rating plate is The Technical rating plate is

2 2 2 2 . . . . Instructions for the installer

Instructions for the installer
Instructions for the installer Instructions for the installer
The following instructions are addressed to the qualified installer to enable him to perform the
correct installation, electric and water connection operations in conformity with current safety
legislation in force in the place where the appliance is installed.
The manufacturer will not respond for damage to people, animals and property due to
installation errors. Likewise the manufacturer is not responsible for breakage caused to the
appliance by incorrect installation.
2.1

2.1 Storage

Storage
2.1 2.1 Storage Storage
If the appliance has been stored in a warehouse at a temperature below 0°C (min. allowed is –
10°C), it should be brought to a temperature of at least +10°C before it is turned on.
2.2

2.2 Transporting the oven

Transporting the oven
2.2 2.2 Transporting the oven Transporting the oven
During transport, the appliance must be left in its original wooden cage to protect it against
damage.
2.3 Unpacking the oven 2.3 Unpacking the oven
2.3 2.3 Unpacking the oven Unpacking the oven
Remove all the packaging before installation, which is formed of a wooden cage that holds the
appliance and cardboard casing to protect it. Check that the appliance has not been damaged
during transport and if any damage is discovered immediately inform your retailer and/or the
haulier.
2.4 Removing the protective film 2.4 Removing the protective film
2.4 2.4 Removing the protective film Removing the protective film
Before using the appliance, carefully remove the special protective film over the stainless steel
parts, without leaving any glue residue on the surfaces. If necessary, remove the residue at once
with a suitable non-inflammable solvent (e.g. acetone).
2.5 Disposing of the packaging 2.5 2.5 2.5 Disposing of the packaging Disposing of the packaging Disposing of the packaging
The packaging must be disposed of in accordance with current legislation in force in the place
where the appliance is installed. The various types of materials (wood – paper – cardboard –
nylon – metal staples) used for the packaging must be separated and delivered to the specific
waste disposal centres. In all circumstances the environmental protection regulations must be
strictly adhered to.
page 6 _________________________________________________________________________________________
Tecnoeka S.r.l., Via Marco Polo, 11
35010 Borgoricco (Padova) ITALY
KF 1 1 1 1 11 111 1 1 1 E E E E UD UD
KF KF 11 11 UD UD
kW 15
kW 16
kPa 150 520310727
fitted on the rear panel of the oven. fitted on the rear panel of the oven. fitted on the rear panel of the oven.
CERTIFICATION
SERIAL NO.