Configuration And Setup; Initial Configuration; Basic Setup - VersaLogic Hawk Reference Manual

Initial Configuration

The following components are recommended for a typical development system with the Hawk
EPU:

ATX power supply

VL-CBR-5016 paddleboard and cable. Refer to the chapter titled "VL-CBR-5016
Paddleboard", beginning on page 37 for details on the VL-CBR-5016 paddleboard.

USB keyboard and mouse

SATA hard drive

USB CD-ROM drive

LVDS monitor

A thermal solution (using either VersaLogic accessories or a customer-designed
solution)
You will also need an operating system (OS) installation CD-ROM.

Basic Setup

The following steps outline the procedure for setting up a typical development system. The Hawk
should be handled at an ESD workstation or while wearing a grounded antistatic wrist strap.
Before you begin, unpack the Hawk and accessories. Verify that you received all the items you
ordered. Inspect the system visually for any damage that may have occurred in shipping. Contact
Support@VersaLogic.com
Gather all the peripheral devices you plan to attach to the Hawk as well as their interface and
power cables.
It is recommended that you attach standoffs to the board (see Hardware Assembly on page 12) to
stabilize the board and make it easier to work with.
Figure 3 shows a typical setup for the Hawk in the development environment.
VL-EPU-3310 Reference Manual

Configuration and Setup

immediately if any items are damaged or missing.
2
7